CCNA (640-802) Lab – RIPv2 SIMULATOR

Central Florida Widgets recently installed a new router in their WinterPark office. Complete the network installation by performing the initial router configurations and configuring RIPV2 routing using the router command line interface (CLI) on the WinterPark router.

Configure the router per the following requirements:

Name of the router is WinterPark
Enable-secret password is te23lith
The password to access user EXEC mode using the console is Con231D
The password to allow telnet access to the router is toyo12ta
IPV4 addresses must be configured as follows:
Ethernet network 209.165.202.128/27 – router has last assignable host address in subnet
Serial network is 192.0.2.192/28 – router has last assignable host address in the subnet. Interfaces should be enabled.
Router protocol is RIP V2

Corrent Answer:

(1) Name the router:

Router>enable
Router#configure terminal
Router(config)#hostname WinterPark

(2) Set secret password:

WinterPark(config)#enable secret te23lith

(3) Set password for the console:

WinterPark(config)#line console 0
WinterPark(config-line)#password Con231D
WinterPark(config-line)#login
WinterPark(config-line)#exit

(4) Set the Telnet password:

WinterPark(config)#line vty 0 4
WinterPark(config-line)#password toyo12ta
WinterPark(config-line)#login
WinterPark(config-line)#exit

(5) Assign IP address for Ethernet interface (Fa0/0):

The Ethernet network 209.165.202.128/27 has:

Increment: 32 (/27 = 255.255.255.224 or 1111 1111.1111 1111.1111 1111.1110 0000)
Network address: 209.165.202.128
Broadcast address: 209.165.202.159 (because 128 + 32 – 1 = 159)

Therefore the last assignable host address in this subnet is 209.165.202.158 and we will assign it to Fa0/0 interface with these commands:

WinterPark(config)#interface fa0/0
WinterPark(config-if)#ip address 209.165.202.158 255.255.255.224
WinterPark(config-if)#no shutdown
WinterPark(config-if)#exit

(6) Assign IP address for Serial interface (S0/0/0):

Serial network 192.0.2.192/28 has:

Increment: 16 (/28 = 255.255.255.240 or 1111 1111.1111 1111.1111 1111.1111 0000)
Network address: 192.0.2.192
Broadcast address: 192.0.2.207 (because 192 + 16 – 1 = 207)

So the last assignable host address in this subnet is 192.0.2.207. Finally we assign it to s0/0/0 interface:

WinterPark(config)#interface s0/0/0
WinterPark(config-if)#ip address 192.0.2.207 255.255.255.240
WinterPark(config-if)#no shutdown
WinterPark(config-if)#exit

(7) Configure RIP v2 routing protocol:

WinterPark(config)#router rip
WinterPark(config-router)#version 2
WinterPark(config-router)#network 209.165.202.128
WinterPark(config-router)#network 192.0.2.207
WinterPark(config-router)#end
WinterPark#copy running-config startup-config

That's all.