2014 Latest Cisco 350-001 Dump Free Download(191-200)!
QUESTION 191
Which two statements best describe spanning-tree BPDU processing for a blocking port? (Choose two.)
A. BPDUs that enter a blocking port are discarded.
B. BPDUs that enter a blocking port are processed.
C. Loopguard puts an interface into a loop-inconsistent state when BPDUs stop being received on a
blocking port.
D. BPDUs are only processed on forwarding ports.
Answer: BC
Explanation:
http://www.infraworld.eu/spanning-tree-root-guard-and-loop-guard/
QUESTION 192
When troubleshooting duplex mismatches, which two are errors that are typically seen on the half duplex end? (Choose two.)
A. excessive collisions
B. FCS errors
C. runts
D. late collisions
Answer: BC
Explanation:
http://www.netcordia.com/resources/tech-tips/switch-port-duplex-mismatch.asp
QUESTION 193
You are using VTP (version 2) in your network to transport VLAN information between switches. When adding a switch to the network (that has been used in the lab previously), you notice that a lot of the existing VLANs have been deleted or replaced with other names. What can you do to prevent this from happening in the future, without losing all VTP features that you are using today?
A. configure a hard-to-guess VTP domain name
B. use a hard-to-guess VTP password
C. use VTP transparent mode
D. implement VTP version 3
Answer: D
Explanation:
http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps708/solution_guide_c78_508010.
html
QUESTION 194
Which two combinations are valid PAgP configurations that will set up a PAgP channel? (Choose two.)
A. On-Passive
B. On-Auto
C. Passive-Active
D. Desirable-Auto
E. Active-Active
F. Desirable-Desirable
Answer: DF
Explanation:
http://www.cisco.com/en/US/products/hw/switches/ps607/products_configuration_example09186 a0080094789.shtml (see port aggregation protocol)
QUESTION 195
Which three causes could prevent a host from getting an IPv6 address with stateless autoconfiguration? (Choose three.)
A. The autoconfig command is missing from the router interface.
B. IPv6 multicast routing is not enabled on the router interface.
C. IPv6 unicast routing is not enabled on the router interface.
D. The router interface is configured with a /63 mask.
E. The router interface is configured with a /65 mask.
Answer: CDE
QUESTION 196
Which two IPv6 address pairs can be assigned on a point-to-point link with a /125 mask? (Choose two.)
A. 2001:DB8::1 and 2001:DB8::2
B. 2001:DB8::9 and 2001:DB8::10
C. 2001:DB8::10 and 2001:DB8::17
D. 2001:DB8::1 and 2001:DB8::18
Answer: AC
QUESTION 197
Which two of the following are considered valid router IDs for EIGRPv6? (Choose two.)
A. 0.0.0.1
B. 0.255.0.1
C. 2001:DB8::1
D. 2001:DB8:ABCD:FEEF::1
Answer: AB
QUESTION 198
Which two tunneling techniques in IPv6 do not require an IPv4 tunnel destination in the configuration? (Choose two.)
A. 6to4
B. 6over4
C. ISATAP
D. GRE
Answer: AC
When a BGP router is not capable of understanding 4-byte AS numbers, it will see 4-byte AS numbers as a special, reserved, 2-byte AS number in the AS path. Which 2-byte AS number is this reserved one?
A. 00000
B. 12345
C. 23456
D. 65000
E. 99999
Answer: C
Explanation:
http://www.cisco.com/web/about/security/intelligence/4byte-as.html
QUESTION 199
What are the “bound IP addresses” used for in LDP?
A. For each such address and mask /32, one label binding is created.
B. As the TCP endpoint, IP addresses are used by the LDP session.
C. These addresses are used to find the label binding to put in the LFIB, by looking up these IP
addresses in the routing table.
D. These addresses are used for penultimate hop popping (PHP) when forwarding packets to the
next router directly.
Answer: C
Explanation:
In case of liberal label retention Label Information Base (LIB) maintains remote binding information through down streaming or through upcoming hop. The label binding is utilized in Label forwarding information base (LFIB) but no other labels are kept which are not used for forwarding packets. The cause for storing remote binding in LFIB is subject to topological change and implementation of dynamic routing due to downlink of router. Conservative label retention mode configure on an LSR does not contain all remote bindings except an associated upcoming hop in its LIB. However LLR will help in rapid routing topological change while CLR utilizes memory efficiently.
QUESTION 200
What does the OSPF command capability vrf-lite achieve?
A. It enables provider edge (PE) specific checks on a router when the OSPF process is associated
with the VRF.
B. It disables provider edge (PE) specific checks on a router when the OSPF process is associated
with the VRF.
C. It enables the exchange of the “VRF-Lite” capability when the OSPF adjacency is formed.
D. It disables the MPLS processing on the OSPF learned routes inside the VRF.
Answer: B
Explanation:
http://www.cisco.com/en/US/docs/ios/12_0st/12_0st21/feature/guide/ospfvrfl.html
If you want to pass the Cisco 350-001 Exam sucessfully, recommend to read latest Cisco 350-001 Dump full version.
